Subject	Also the CAS position should be fine. Check if you have any
Posted by	Polishzx on February 07, 2020 at 11:26 PM
	This message has been viewed 357 times.
In Reply To	If you're really that concerned, check out this prelube tank posted by Polishzx on February 07, 2020 at 11:17 PM
Message	old photos that you might be able to use to eyeball orientation. Otherwise, middle should be fine until you can set it with timing light. Use a spark plug wire between the #1 coil pack and #1 spark plug so you can get an accurate reading with your timing gun, instead of using the PTU loop. Some timing guns work better with the PTU loop than others.
Follow Ups	Starting rebuilt engine guidance - Kvert 19:38:03 02/07/20 From what I understand you disconnect the fuel system (n/m) - ctheobal 21:02:06 02/07/20 To prime oil - BlackholeZ 22:47:03 02/07/20 2nd - vorpalZed 09:28:41 02/08/20 And keep a wrench handy to clang on a jackstand. (n/m) - MixManMash 15:36:08 02/08/20 *rolls eyes... whistles* (n/m) - vorpalZed 22:16:03 02/08/20 lol thats so messed up... i swear I'd grab the nearest - nonstopna 18:51:02 02/09/20 If you're really that concerned, check out this prelube tank - Polishzx 23:17:45 02/07/20 Also the CAS position should be fine. Check if you have any - Polishzx 23:26:48 02/07/20 Yeah those are nice. - BlackholeZ 01:28:09 02/08/20 I've fired up many new longblocks.. - Stanky (BC) 11:02:26 02/08/20 I did the same, no issues. - platinumist 13:38:40 02/08/20 This. (n/m) - MixManMash 15:33:26 02/08/20 Agreed. I do the same. (n/m) - Woody75 (Denver) 12:50:17 02/10/20 i used Guapo's guide in the faq section. but - slayer fan 13:23:16 02/08/20 Assembly lube on bearing surfaces and cam shaft/lifters - ZXRider 20:08:56 02/08/20 Re: Assembly lube on bearing surfaces and cam shaft/lifters - nonstopna 19:02:48 02/09/20 I was told any assembly lube on the cylinder walls - ZXRider 20:22:40 02/09/20 ^Correct - -Grimm- 13:12:31 02/10/20 Interesting. Why ATF instead of engine oil? - ZXoltan 14:59:44 02/12/20 (From what I was told) ATF acts as a light lubricant for... - -Grimm- 13:06:56 02/13/20 I did have a problem building oil pressure - Rocket man 18:01:09 02/09/20 This is what I have done for the Z as well - -Grimm- 13:15:06 02/10/20 Re: Starting rebuilt engine guidance - Kvert 07:02:31 02/17/20 Re: Starting rebuilt engine guidance - Kvert 07:47:02 02/17/20
Post a Followup	You cannot reply to this message because you are not logged in.