Subject	When I went to get a '90 nose panel, painted to go on my
Posted by	Barry (NJ) on October 22, 2019 at 1:01 PM
	This message has been viewed 172 times.
In Reply To	Thanks for the replies, guys. Better to know than to flush a posted by Woodnutz on October 19, 2019 at 05:26 PM
Message	'95. The body guy asked about the paint code, then brought out a dozen or so paint chips/samples and held them to the hood in good daylight to get a really good match. Came out "near" perfect. So it can be done, but that was a solid, single stage color, plus clear. The pearls are two stage paints, so matching base color, and pearl/flake thickness, is near impossible without some blending, to take away the obvious differences seen an a stark side by side comparison.
Follow Ups	recommendations for paint/body in Socal? Im in the antelope - RonZ300 (Socal) 17:35:34 10/15/19 Pearl paint is very difficult to match, will likely need to - Barry (NJ) 11:01:21 10/16/19 Agreed - I’ve ended up painting the whole car (n/m) - ConVerTT 13:24:05 10/16/19 Even light-colored metallics without pearl are tough - ZXoltan 15:22:51 10/16/19 Repaint, no matter how good the painter is its almost - CmyZ 20:09:41 10/17/19 I know this is Ron's thread, but thanks for chiming in... - Woodnutz 09:46:23 10/18/19 Mine had been garaged most of its life as well so im hoping - RonZ300 (Socal) 09:37:10 10/19/19 QN0, KH6 are hard to match / blend for experienced - ConVerTT 11:38:04 10/19/19 Thanks for the replies, guys. Better to know than to flush a - Woodnutz 17:26:14 10/19/19 When I went to get a '90 nose panel, painted to go on my - Barry (NJ) 13:01:55 10/22/19 Pearl's are actually 3-stage paints, although - ZXoltan 12:54:59 10/25/19 Yeah, I wasn't really counting the clear, 2 + Clear = 3 (n/m) - Barry (NJ) 11:55:18 10/28/19
Post a Followup	You cannot reply to this message because you are not logged in.