TwinTurbo.NET: Nissan 300ZX forum - 3d Printed manifolds are getting common in FSAE
People Seeking Info
 
   


     
Subject 3d Printed manifolds are getting common in FSAE
     
Posted by BlackholeZ on August 07, 2019 at 11:50 PM
  This message has been viewed 146 times.
     
In Reply To I've been expecting a 3d printed intake manifold posted by not4resaleZ on August 07, 2019 at 07:06 PM
     
Message Something that 3d printed parts don't handle well is vibration, which is something that manifolds get a ton of. They work ok for a race weekend but I wouldn't expect them to last long.

But, technology is improving constantly.

-Dan


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne

" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.