Subject	I wasn't very happy with the RPS 6 puck
Posted by	RUZH on July 24, 2019 at 1:50 PM
	This message has been viewed 204 times.
In Reply To	The new SZ pressure plates are designed differently from posted by MixManMash on July 23, 2019 at 07:09 PM
Message	Clutch pedal is really hard to operate specially from dead stop first gear, have to be careful not to stall the engine and sometimes causes lots of wheel hopping. I'm considering to replace it with a more street friendly clutch. Thanks for the advice!
Follow Ups	Need a flywheel and clutch kit - amezcuaz32 19:57:32 07/17/19 Advice: - CameronSF 20:08:34 07/17/19 Re: Need a flywheel and clutch kit - itsa300zx 20:25:37 07/17/19 $250 cdn. For the kit so well within your budget. (n/m) - itsa300zx 22:22:27 07/17/19 Re: Need a flywheel and clutch kit - Metacom 21:20:58 07/17/19 Contact joe @ ZSPEED - Drk93TT 06:14:36 07/19/19 Me too... clutch died on me today! - RUZH 14:49:41 07/20/19 Was the clutch pedal adjusted properly? - MixManMash 07:57:32 07/22/19 The clutch pedal doesn't have any pressure... - RUZH 23:59:38 07/22/19 Hydraulics - ZXoltan 07:50:40 07/23/19 Unless the internal seals have failed, in which case you - MixManMash 19:09:58 07/23/19 I couldn't see any leaked fluids from the clutch cylinders - RUZH 13:42:13 07/24/19 The new SZ pressure plates are designed differently from - MixManMash 19:09:19 07/23/19 I wasn't very happy with the RPS 6 puck - RUZH 13:50:35 07/24/19 I agree. I have driven a Z32 with that same clutch. It's - MixManMash 20:59:28 07/24/19
Post a Followup	You cannot reply to this message because you are not logged in.