Subject	Re: Do you have the instructions? download for PN: 30-6620
Posted by	Guyver1 on March 12, 2019 at 2:57 AM
	This message has been viewed 308 times.
In Reply To	Do you have the instructions? download for PN: 30-6620 posted by LitlElvis on March 12, 2019 at 02:49 AM
Message	yes i have.. but i see it refered to cable connection from V1 to V2 and if you use a calibration for V1 on V2. this is the description: The EMS functions assigned to certain pins have been changed and no longer match the 30-1620 EMS. Unless otherwise noted, the following pins and functions will need to be manually reconfigured after using AEMTuner to convert a V1.19 (30-1620, Series 1 EMS) calibration for use with the 30-6620 Series 2 hardware
Follow Ups	Problem with AEM EMS V2 on my95 - Guyver1 00:56:24 03/12/19 Sounds like the extension patch has a few wires mixed up - LitlElvis 01:53:40 03/12/19 Re: Sounds like the extension patch has a few wires mixed up - Guyver1 02:07:16 03/12/19 Are you using the extension patch also with the stock ECU? (n/m) - LitlElvis 02:21:29 03/12/19 Re: Are you using the extension patch also with the stock ECU? - Guyver1 02:32:35 03/12/19 Ooops, I see that you connected the AEM to the stock harness - LitlElvis 02:36:29 03/12/19 Re: Ooops, I see that you connected the AEM to the stock harness - Guyver1 02:38:53 03/12/19 Do you have the instructions? download for PN: 30-6620 - LitlElvis 02:49:12 03/12/19 Re: Do you have the instructions? download for PN: 30-6620 - Guyver1 02:57:38 03/12/19 See below... - DVDBURN (MD) 02:13:49 03/14/19 Re: See below... - Guyver1 15:05:37 03/16/19 Re: Problem with AEM EMS V2 on my95 - Guyver1 02:43:08 03/14/19 you shouldn't measure any voltage at pin 30 it's a ground, - LitlElvis 11:59:12 03/14/19 used (n/m) - Guyver1 15:06:46 03/16/19
Post a Followup	You cannot reply to this message because you are not logged in.