TwinTurbo.NET: Nissan 300ZX forum - Ooops, I see that you connected the AEM to the stock harness
Subject
Ooops, I see that you connected the AEM to the stock harness
Posted by
LitlElvis
on March 12, 2019 at 2:36 AM
This message has been viewed
228
times.
In Reply To
Are you using the extension patch also with the stock ECU? (n/m)
posted by LitlElvis
on March 12, 2019 at 02:21 AM
Message
AEM states that the V2 pins 2, 8, 11, 13, 18, 40, 56, 57, 102, and 113 are different than the V1 pins and need to be manually reconfigured during installation. Could these be the problem?
Follow Ups
Problem with AEM EMS V2 on my95
-
Guyver1
00:56:24 03/12/19
Sounds like the extension patch has a few wires mixed up
-
LitlElvis
01:53:40 03/12/19
Re: Sounds like the extension patch has a few wires mixed up
-
Guyver1
02:07:16 03/12/19
Are you using the extension patch also with the stock ECU? (n/m)
-
LitlElvis
02:21:29 03/12/19
Re: Are you using the extension patch also with the stock ECU?
-
Guyver1
02:32:35 03/12/19
Ooops, I see that you connected the AEM to the stock harness -
LitlElvis
02:36:29 03/12/19
Re: Ooops, I see that you connected the AEM to the stock harness
-
Guyver1
02:38:53 03/12/19
Do you have the instructions? download for PN: 30-6620
-
LitlElvis
02:49:12 03/12/19
Re: Do you have the instructions? download for PN: 30-6620
-
Guyver1
02:57:38 03/12/19
See below...
-
DVDBURN (MD)
02:13:49 03/14/19
Re: See below...
-
Guyver1
15:05:37 03/16/19
Re: Problem with AEM EMS V2 on my95
-
Guyver1
02:43:08 03/14/19
you shouldn't measure any voltage at pin 30 it's a ground,
-
LitlElvis
11:59:12 03/14/19
used (n/m)
-
Guyver1
15:06:46 03/16/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.