TwinTurbo.NET: Nissan 300ZX forum - Thanks Bernie. (n/m)
Subject
Thanks Bernie. (n/m)
Posted by
SirpriZ
on February 08, 2019 at 1:30 PM
This message has been viewed
237
times.
In Reply To
Outside down.
posted by Bernie (NoVA)
on February 08, 2019 at 10:13 AM
Message
Follow Ups
Step on flywheel. I am getting a stock flywheel lightened
-
SirpriZ
16:25:19 02/07/19
0.008-0.010" is the step height, It does the opposite
-
itsa300zx
17:05:12 02/07/19
I'm having trouble "seeing" what you are describing though
-
SirpriZ
17:25:18 02/07/19
The pressure plate casing is bolted 0.008" lower not higher
-
itsa300zx
17:34:29 02/07/19
Are you saying the outer machined edge is supposed to be
-
SirpriZ
18:02:56 02/07/19
Correct. Your used flywheel is machined wrong
-
itsa300zx
18:42:00 02/07/19
I got it. Called shop and had them cut outer
-
SirpriZ
19:28:25 02/07/19
Outside down.
-
Bernie (NoVA)
10:13:40 02/08/19
Thanks Bernie. (n/m) -
SirpriZ
13:30:15 02/08/19
Is this necesary for a non-OEM clutch as well?
-
Mr.Stacy
13:36:11 02/08/19
it's optional (n/m)
-
Bernie (NoVA)
17:42:02 02/08/19
but FWIW the RPS, Fidanza, JWT flywheels all come stepped (n/m)
-
Bernie (NoVA)
16:27:07 02/11/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.