TwinTurbo.NET: Nissan 300ZX forum - I got it. Called shop and had them cut outer
People Seeking Info
 
   


     
Subject I got it. Called shop and had them cut outer
     
Posted by SirpriZ on February 07, 2019 at 7:28 PM
  This message has been viewed 251 times.
     
In Reply To Correct. Your used flywheel is machined wrong posted by itsa300zx on February 07, 2019 at 06:42 PM
     
Message edge .008" BELOW friction surface. Thanks for your help.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.