TwinTurbo.NET: Nissan 300ZX forum - 0.008-0.010" is the step height, It does the opposite
Subject
0.008-0.010" is the step height, It does the opposite
Posted by
itsa300zx
on February 07, 2019 at 5:05 PM
This message has been viewed
378
times.
In Reply To
Step on flywheel. I am getting a stock flywheel lightened
posted by SirpriZ
on February 07, 2019 at 04:25 PM
Message
of what you and the shop thinks that it reduces clamping force. The center of the flywheel (dia of the friction disc) is 0.008" higher than the edges.
Follow Ups
Step on flywheel. I am getting a stock flywheel lightened
-
SirpriZ
16:25:19 02/07/19
0.008-0.010" is the step height, It does the opposite -
itsa300zx
17:05:12 02/07/19
I'm having trouble "seeing" what you are describing though
-
SirpriZ
17:25:18 02/07/19
The pressure plate casing is bolted 0.008" lower not higher
-
itsa300zx
17:34:29 02/07/19
Are you saying the outer machined edge is supposed to be
-
SirpriZ
18:02:56 02/07/19
Correct. Your used flywheel is machined wrong
-
itsa300zx
18:42:00 02/07/19
I got it. Called shop and had them cut outer
-
SirpriZ
19:28:25 02/07/19
Outside down.
-
Bernie (NoVA)
10:13:40 02/08/19
Thanks Bernie. (n/m)
-
SirpriZ
13:30:15 02/08/19
Is this necesary for a non-OEM clutch as well?
-
Mr.Stacy
13:36:11 02/08/19
it's optional (n/m)
-
Bernie (NoVA)
17:42:02 02/08/19
but FWIW the RPS, Fidanza, JWT flywheels all come stepped (n/m)
-
Bernie (NoVA)
16:27:07 02/11/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.