Subject	Did you take the rear hub off or take the whole car someplac (n/m)
Posted by	moxie (SF) on January 10, 2019 at 10:49 AM
	This message has been viewed 300 times.
In Reply To	It's cast aluminum so I didn't do it. This is the second posted by Musashi Sword on January 10, 2019 at 10:37 AM
Message
Follow Ups	Does anyone know what the name of the big round gasket - Musashi Sword 10:48:45 01/09/19 it's a seal (n/m) - LitlElvis 13:27:21 01/09/19 The big round seal then. (n/m) - Musashi Sword 14:11:20 01/09/19 Bingo! (n/m) - LitlElvis 23:33:05 01/10/19 :) (n/m) - Musashi Sword 09:16:52 01/11/19 Check here - Polish 13:30:54 01/09/19 That's it. Rear hub, grease seal. Thanks! (n/m) - Musashi Sword 14:05:34 01/09/19 Where you the one that welded the rear brake mounting bracke - moxie (SF) 09:25:01 01/10/19 It's cast aluminum so I didn't do it. This is the second - Musashi Sword 10:37:57 01/10/19 Did you take the rear hub off or take the whole car someplac (n/m) - moxie (SF) 10:49:05 01/10/19 I got a spare set from Tim so I could do the swap at one - Musashi Sword 11:04:26 01/10/19 How much did the welding cost? And how much of a pita is it - moxie (SF) 16:00:06 01/10/19 On my blue TT it was done while the whole rear end was - Musashi Sword 09:16:32 01/11/19 Here it is with the rotor in place. - Musashi Sword 10:41:32 01/10/19 The STI brembo rears bolt on - no welding needed. (n/m) - Bernie (NoVA) 07:49:30 01/16/19 Jerry. (n/m) - Bernie (NoVA) 14:20:28 01/12/19 Can it be Tom? (n/m) - Musashi Sword 06:24:44 01/14/19
Post a Followup	You cannot reply to this message because you are not logged in.