Subject	A few more questions if you have a sec:
Posted by	Mongoose on November 30, 2018 at 10:39 PM
	This message has been viewed 161 times.
In Reply To	Very simple posted by ZaXxon on November 20, 2018 at 09:54 AM
Message	Why did you remove the baffle plates? Was it to clean underneath after drilling, or just to install the brass wool? What purpose does the brass wool serve inside the cam covers? Where did you mount the catch can? Thanks again!
Follow Ups	5+ Years and 8000+ miles since rebuild - ZaXxon 07:37:00 11/18/18 Impressively clean! - ZXoltan 11:20:29 11/18/18 OEM Grommets (n/m) - ZaXxon 16:12:48 11/18/18 Anyone used these Z-Spec valve cover grommets? - ZXoltan 08:51:37 11/19/18 I just ordered those to give them a try. - ZaXxon 09:28:21 11/19/18 I didn't like them. The OEM grommets have a metal washer - Barry (NJ) 10:08:12 11/19/18 Anyone tried the BDE solution for valve covers? - ZXoltan 13:50:22 11/19/18 For such a simple system, it's not a simple answer... - LitlElvis 13:07:52 11/20/18 Interesting... especially since the exhaust cam covers don't - ZaXxon 17:04:44 11/20/18 Yeah, never figured out why exhaust has RTV instead of bolts (n/m) - ZXoltan 21:06:46 11/20/18 nismo oil cap gets hot doesn't it ... (n/m) - The Devils Z 12:42:24 11/18/18 Never noticed. Like hotter than other engine things? (n/m) - ZaXxon 09:29:20 11/19/18 OEM is plastic, so doesn't soak up as much heat as AL ;-) (n/m) - Barry (NJ) 10:16:14 11/19/18 I had a Nismo cap, and definitely got hotter than OEM (n/m) - ZXoltan 13:51:25 11/19/18 OGs rock these... - Bernie (NoVA) 23:17:34 11/26/18 Fancy ;-) (n/m) - Barry (NJ) 13:15:08 11/27/18 Do you track this car? - CameronSF 13:23:29 11/19/18 No, I do not. (n/m) - ZaXxon 14:17:12 11/19/18 Can you give a short writeup of your delete/catch can setup? - Mongoose 22:38:09 11/19/18 Very simple - ZaXxon 09:54:10 11/20/18 A few more questions if you have a sec: - Mongoose 22:39:15 11/30/18
Post a Followup	You cannot reply to this message because you are not logged in.