TwinTurbo.NET: Nissan 300ZX forum - UAS kit depends on urethane bushings and will fail just like
People Seeking Info
 
   


     
Subject UAS kit depends on urethane bushings and will fail just like
     
Posted by Bernie (NoVA) on November 06, 2018 at 6:13 PM
  This message has been viewed 207 times.
     
In Reply To Front camber adjustment with factory uppers and lowers? posted by RonZ300 (Socal) on November 06, 2018 at 09:56 AM
     
Message the STILLEN arms with time. Same issue has been seen on Z1 Street, Stillen, Noltec, & Whiteline. The stock upper arm bushings are actually bearing loaded and can free spin & move without binding. Any urethane bushing with a metal sleeve will eventually dry up, make noise then fail outright like this:

https://www.yugobernie.com/images/FUCA_Stillen_Failure/





Bernie Bilski
berniebilski@cox.net
President of Z-Car Club of Northern Virginia

1995 Nissan 300ZX TwinTurbo in Cobalt Green
1997 Nissan 240SX SE in Ultra Red
2006 Nissan Frontier SE in Ultra Black



     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.