TwinTurbo.NET: Nissan 300ZX forum - Not for two inches. They are adjusted to the safety stops
People Seeking Info
 
   


     
Subject Not for two inches. They are adjusted to the safety stops
     
Posted by ConVerTT on October 25, 2018 at 9:52 AM
  This message has been viewed 175 times.
     
In Reply To A lift would be shimmed up at the low end. It must be level (n/m) posted by Gordo NA2LS Daytona on October 25, 2018 at 09:35 AM
     
Message on site, which makes the ramps parallel-ish to the floor. ( I say parallel-ish because there is a bit of wiggle room to level between the stops). Unless you have an extreme drop (4-6 inches) - in which case I agree they will need to shim.

ConVerTT - 93 Hi Compression TT Convertible (black)
XtraVerTT - 93 Hi Compression TT Convertible (glacier white)
SlickTTop - 96 OBD1 TT Slicktop (black)
Old Yeller - 90 Slicktop NA (PGY)
RedZed - 90 "factory" 2+0 TT
EmoZed - 89 RHD for parts - RIP

And their hot Asian Cousin - 01 Acura NSX NA

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.