TwinTurbo.NET: Nissan 300ZX forum - Often times the correct repair is not epoxy
People Seeking Info
 
   


     
Subject Often times the correct repair is not epoxy
     
Posted by BlackholeZ on July 14, 2018 at 1:41 AM
  This message has been viewed 270 times.
     
In Reply To Not going to comment on the he said she said. posted by Goldchocobo on July 13, 2018 at 07:06 PM
     
Message but urethane. That or there are "toughened" epoxies that have been modified to have a bit of flex to prevent cracking. That said, I've fixed holes in oil pans with JB Weld, while the engine was still hot. Just have to have the right tool for the job.

-Dan


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne

" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.