TwinTurbo.NET: Nissan 300ZX forum - Shhhhh..... :)
People Seeking Info
 
   


     
Subject Shhhhh..... :)
     
Posted by Woody75 (Denver) on April 17, 2018 at 2:10 PM
  This message has been viewed 693 times.
     
In Reply To Woody75 made a pretty cool setup with his 3D printer posted by LitlElvis on April 17, 2018 at 11:56 AM
     
Message Still going strong so far. Went through a few design tweeks. Hardest part actually was finding a handle that I liked and that worked. Simple design. Bottom portion is connected to the main rod. Upper portion floats up and down. The handle screws in and tightens everything against the gears. Locks both gears in place.

***** Do not ask me to make you one or for the files. I'm working on trying to get some molds made and see if I can make some myself. 3d printing them takes way too long and I would want something stronger if I were going to produce and sell them. But this will not be something that happens quickly or at all.


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.