Subject	Ideally it'd be spraying toward the back of the valve
Posted by	BlackholeZ on March 10, 2018 at 10:44 PM
	This message has been viewed 219 times.
In Reply To	Does a fuel injector need to spray onto a surface? posted by TheKryptKeeper on March 10, 2018 at 02:39 PM
Message	However because of packaging that isn't always possible. There will be some runner wall wetting (which is part of why you need a more fuel on cold starts) but "ideally" the air velocity pulls the fuel along with it. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Does a fuel injector need to spray onto a surface? - TheKryptKeeper 14:39:29 03/10/18 Ideally it'd be spraying toward the back of the valve - BlackholeZ 22:44:05 03/10/18
Post a Followup	You cannot reply to this message because you are not logged in.