Subject	I will 2nd that, BK (n/m)
Posted by	Joe@Dewla_DeZign on March 09, 2018 at 8:36 PM
	This message has been viewed 234 times.
In Reply To	Do you have any silver P/C'd? posted by ZXoltan on March 08, 2018 at 08:00 AM
Message
Follow Ups	Suggestions on OEM "correct" paint for 90 TT valve covers - GrecV2 21:44:35 03/07/18 I would suggest a satin black powder coat instead of - Bernie (NoVA) 07:20:55 03/08/18 Do you have any silver P/C'd? - ZXoltan 08:00:01 03/08/18 I will 2nd that, BK (n/m) - Joe@Dewla_DeZign 20:36:05 03/09/18 I just had them strip mine with M/A (n/m) - Joe@Dewla_DeZign 20:37:47 03/09/18 How much w/ out the gasket kit? Any in a gloss black? (n/m) - CarolinaZ_TT 12:40:00 03/08/18 I might - will check (n/m) - Bernie (NoVA) 16:47:54 03/08/18 Here is what I have... - Bernie (NoVA) 09:34:53 03/10/18 Depends... - vorpalZ 10:38:41 03/08/18 Pretty sure bare alum started in 94 or 95, black b4 that (n/m) - ZXoltan 16:39:22 03/08/18 Black 90-91, raw aluminum 1992+ (n/m) - Bernie (NoVA) 10:46:17 03/09/18 This. (n/m) - MixManMash 19:13:37 03/09/18 Sounds like satin black is what I'm after... - GrecV2 11:11:39 03/08/18 Re: Suggestions on OEM "correct" paint for 90 TT valve covers - succafool 11:57:38 03/08/18 I'm almost done 'remodeling' my PC setup... - -Grimm- 13:12:50 03/08/18 If your goal is a stock look, then satin black is the best - Mike TDK (NoVA) 00:49:34 03/09/18
Post a Followup	You cannot reply to this message because you are not logged in.