Subject	If your goal is a stock look, then satin black is the best
Posted by	Mike TDK (NoVA) on March 09, 2018 at 12:49 AM
	This message has been viewed 249 times.
In Reply To	Suggestions on OEM "correct" paint for 90 TT valve covers posted by GrecV2 on March 07, 2018 at 09:44 PM
Message	choice. I believe the earlier Z32's only painted the inner valve covers black, the outer covers were unpainted. You could have the inner covers powder coated black, and have the outer covers dunked/blasted and powder coated with clear.
Follow Ups	Suggestions on OEM "correct" paint for 90 TT valve covers - GrecV2 21:44:35 03/07/18 I would suggest a satin black powder coat instead of - Bernie (NoVA) 07:20:55 03/08/18 Do you have any silver P/C'd? - ZXoltan 08:00:01 03/08/18 I will 2nd that, BK (n/m) - Joe@Dewla_DeZign 20:36:05 03/09/18 I just had them strip mine with M/A (n/m) - Joe@Dewla_DeZign 20:37:47 03/09/18 How much w/ out the gasket kit? Any in a gloss black? (n/m) - CarolinaZ_TT 12:40:00 03/08/18 I might - will check (n/m) - Bernie (NoVA) 16:47:54 03/08/18 Here is what I have... - Bernie (NoVA) 09:34:53 03/10/18 Depends... - vorpalZ 10:38:41 03/08/18 Pretty sure bare alum started in 94 or 95, black b4 that (n/m) - ZXoltan 16:39:22 03/08/18 Black 90-91, raw aluminum 1992+ (n/m) - Bernie (NoVA) 10:46:17 03/09/18 This. (n/m) - MixManMash 19:13:37 03/09/18 Sounds like satin black is what I'm after... - GrecV2 11:11:39 03/08/18 Re: Suggestions on OEM "correct" paint for 90 TT valve covers - succafool 11:57:38 03/08/18 I'm almost done 'remodeling' my PC setup... - -Grimm- 13:12:50 03/08/18 If your goal is a stock look, then satin black is the best - Mike TDK (NoVA) 00:49:34 03/09/18
Post a Followup	You cannot reply to this message because you are not logged in.