TwinTurbo.NET: Nissan 300ZX forum - Do you have any silver P/C'd?
Subject
Do you have any silver P/C'd?
Posted by
ZXoltan
on March 08, 2018 at 8:00 AM
This message has been viewed
273
times.
In Reply To
I would suggest a satin black powder coat instead of
posted by Bernie (NoVA)
on March 08, 2018 at 07:20 AM
Message
Do you offer them with the PCV relocation done?
Do you remove the baffles to clean underneath (especially after beadblasting?)
Thanks Bernie.
Follow Ups
Suggestions on OEM "correct" paint for 90 TT valve covers
-
GrecV2
21:44:35 03/07/18
I would suggest a satin black powder coat instead of
-
Bernie (NoVA)
07:20:55 03/08/18
Do you have any silver P/C'd? -
ZXoltan
08:00:01 03/08/18
I will 2nd that, BK (n/m)
-
Joe@Dewla_DeZign
20:36:05 03/09/18
I just had them strip mine with M/A (n/m)
-
Joe@Dewla_DeZign
20:37:47 03/09/18
How much w/ out the gasket kit? Any in a gloss black? (n/m)
-
CarolinaZ_TT
12:40:00 03/08/18
I might - will check (n/m)
-
Bernie (NoVA)
16:47:54 03/08/18
Here is what I have...
-
Bernie (NoVA)
09:34:53 03/10/18
Depends...
-
vorpalZ
10:38:41 03/08/18
Pretty sure bare alum started in 94 or 95, black b4 that (n/m)
-
ZXoltan
16:39:22 03/08/18
Black 90-91, raw aluminum 1992+ (n/m)
-
Bernie (NoVA)
10:46:17 03/09/18
This. (n/m)
-
MixManMash
19:13:37 03/09/18
Sounds like satin black is what I'm after...
-
GrecV2
11:11:39 03/08/18
Re: Suggestions on OEM "correct" paint for 90 TT valve covers
-
succafool
11:57:38 03/08/18
I'm almost done 'remodeling' my PC setup...
-
-Grimm-
13:12:50 03/08/18
If your goal is a stock look, then satin black is the best
-
Mike TDK (NoVA)
00:49:34 03/09/18
Post a
Followup
You cannot reply to this message because you are not
logged in
.