TwinTurbo.NET: Nissan 300ZX forum - I buy Ash-spec products from SZ. Only way I will/would buy. (n/m)
I buy Ash-spec products from SZ. Only way I will/would buy. (n/m)
on February 09, 2018 at 1:21 PM
This message has been viewed
In Reply To
posted by Bigwill837
on February 09, 2018 at 12:32 PM
CZP 2.5" Piping & Bell 2.5" SMIC w/ Ducts
I don't think they fit very well
This. My one car has the CZP piping and the other has the
Order their products from another vendor
Order the Ash piping from a vendor like Specialty-Z... (n/m)
I'll hop in too: This is why SZ carries his parts
That should be the other way around....
I buy Ash-spec products from SZ. Only way I will/would buy. (n/m) -
Agreed. I will never send As(s)h money directly again. (n/m)
go via Specialty Z . (n/m)
I second Z1 piping not fitting well at all.
I'm curious why there aren't more 2.5" piping kits
It's really not that easy
It's also not that hard (n/m)
Then give it a shot.
The only quality issue I noticed was with the inlet
Yes - basically weld quality dropped, both there and on the
Yes, I noticed the drop in weld quality as well (n/m)
nope, bends wont get around tight spots (n/m)
You can still buy the Bell intercoolers direct from Bell (n/m)
Re: You can still buy the Bell intercoolers direct from Bell
I believe Ash uses Bell cores IIRC. (n/m)
I liked them enough to buy a set. Beautiful welds, quality
I've worked with (installed) all 3.
Can't get CZP piping anymore.
CZP pipes were ovalled for easier fit in certain areas. (n/m)
Ash piping is a good fit... with some work around it :) (n/m)
You cannot reply to this message because you are not