TwinTurbo.NET: Nissan 300ZX forum - I anxiously await the answer to this question.
I anxiously await the answer to this question.
on December 04, 2017 at 5:13 PM
This message has been viewed
In Reply To
posted by Barry (NJ)
on December 04, 2017 at 12:48 PM
I almost cut it off when I was trying to feed it through my MSP manifolds.
The weird little tab, welded towards the top of
I anxiously await the answer to this question. -
Feed it through?
ah.. I'm sure you're right. I just remember it being in
It does if you assemble the entire engine and forget it ;) (n/m)
2nd that... it won't go through with the manifold on
Ahhh yes... AmateurZ at work... 3 steps forward
Any other Nissan models use the same dipstick?
The bracket bolts to the head, via the valve cover
Hes asking about the spot welded tab
Well, my initial question and first pic was
You cannot reply to this message because you are not