TwinTurbo.NET: Nissan 300ZX forum - Thanks Bernie. Good save. (n/m)
Subject
Thanks Bernie. Good save. (n/m)
Posted by
ZUL8R
on November 27, 2017 at 10:55 AM
This message has been viewed
319
times.
In Reply To
You may be able to sell the cams & lifters (n/m)
posted by Bernie (NoVA)
on November 27, 2017 at 09:36 AM
Message
Follow Ups
Any point in keeping warped heads?
-
ZUL8R
18:01:21 11/26/17
19 thou off, not 12.
-
ZUL8R
18:09:04 11/26/17
According to the FSM, not usable.
-
MixManMash
18:35:16 11/26/17
Thanks MMM. Off to the scrapper! (n/m)
-
ZUL8R
20:20:05 11/26/17
Bah
-
aliaZ
19:47:02 11/29/17
So, what's the limit then? (n/m)
-
MixManMash
07:03:56 11/30/17
There are other factors to consider beside the deck surface
-
-Grimm-
13:42:55 11/30/17
yep
-
aliaZ
03:23:08 12/04/17
hard to say
-
aliaZ
03:32:41 12/04/17
You may be able to sell the cams & lifters (n/m)
-
Bernie (NoVA)
09:36:12 11/27/17
Thanks Bernie. Good save. (n/m) -
ZUL8R
10:55:00 11/27/17
Valves worth keeping at all? (n/m)
-
Zluster
12:26:02 11/27/17
If they are not the early ones - they can be reused. (n/m)
-
Bernie (NoVA)
22:32:50 11/27/17
Am I correct in remembering the TT valves are different?
-
Zluster
11:03:56 11/29/17
If you werent so far away I would take them for R&D
-
-Grimm-
14:06:37 11/29/17
Steven, you're alive...
-
ZXoltan
09:34:53 11/30/17
Im dying slowly...
-
-Grimm-
11:01:50 11/30/17
What casting #? I'm looking for a scrap 48P (n/m)
-
LitlElvis
11:57:26 11/30/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.