TwinTurbo.NET: Nissan 300ZX forum - Kent do the heads, while your at it. It's better now than
Subject
Kent do the heads, while your at it. It's better now than
Posted by
CmyZ
on October 19, 2017 at 10:11 PM
This message has been viewed
249
times.
In Reply To
yeah so one side of me says run it as is
posted by ConVerTT
on October 17, 2017 at 10:30 PM
Message
later. Pulling the engine and redoing it twice is not fun. No matter how many helpers are available.
Follow Ups
Leakdown test results...issues?
-
ConVerTT
11:42:57 10/17/17
My #3 is the lowest as well
-
BlackholeZ
12:07:28 10/17/17
What about 6?
-
ConVerTT
12:36:37 10/17/17
compression #'s
-
ConVerTT
13:07:52 10/17/17
Is that a running engine or one you just installed? (n/m)
-
DAYTONAZ
16:40:40 10/17/17
Just got it. Not installed yet. Those are cold numbers.
-
ConVerTT
17:01:15 10/17/17
In that case I wouldn't over think it
-
DAYTONAZ
13:27:27 10/18/17
It will be fine, maybe a valve has some crud and is stuck.
-
CmyZ
21:32:55 10/17/17
yeah so one side of me says run it as is
-
ConVerTT
22:30:19 10/17/17
Kent do the heads, while your at it. It's better now than -
CmyZ
22:11:36 10/19/17
good point (n/m)
-
ConVerTT
23:58:17 10/21/17
Hmm
-
BlackholeZ
22:05:59 10/17/17
Thats what I would have thought too ...
-
ConVerTT
22:38:20 10/17/17
I wish I had a spare motor sitting around to play with... (n/m)
-
BlackholeZ
23:35:58 10/17/17
If that’s the motor you bought.
-
Aaronw
12:19:26 10/17/17
Looks pretty good! (n/m)
-
JMartz
13:53:15 10/17/17
Looks about right for a used engine
-
-Grimm-
14:14:54 10/17/17
So pretty close to my numbers on cylinder 3
-
ConVerTT
14:56:40 10/17/17
Nowhere near (reading the gauge backwards)
-
-Grimm-
15:31:32 10/18/17
#ValveRegrind????
-
MixManMash
19:10:52 10/18/17
ohhhh sorry! I thought you were using short hand...
-
ConVerTT
19:59:21 10/18/17
Cold is not the same, engine should be at operating temp
-
CmyZ
21:35:19 10/17/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.