TwinTurbo.NET: Nissan 300ZX forum - In that case I wouldn't over think it
Subject
In that case I wouldn't over think it
Posted by
DAYTONAZ
on October 18, 2017 at 1:27 PM
This message has been viewed
289
times.
In Reply To
Just got it. Not installed yet. Those are cold numbers.
posted by ConVerTT
on October 17, 2017 at 05:01 PM
Message
It could simply be a granual of carbon or debris in the valve seat. Those numbers look very good otherwise. Get it running and go from there. It may just need a little run time with some quality oil and fuel to settle itself out.
Follow Ups
Leakdown test results...issues?
-
ConVerTT
11:42:57 10/17/17
My #3 is the lowest as well
-
BlackholeZ
12:07:28 10/17/17
What about 6?
-
ConVerTT
12:36:37 10/17/17
compression #'s
-
ConVerTT
13:07:52 10/17/17
Is that a running engine or one you just installed? (n/m)
-
DAYTONAZ
16:40:40 10/17/17
Just got it. Not installed yet. Those are cold numbers.
-
ConVerTT
17:01:15 10/17/17
In that case I wouldn't over think it -
DAYTONAZ
13:27:27 10/18/17
It will be fine, maybe a valve has some crud and is stuck.
-
CmyZ
21:32:55 10/17/17
yeah so one side of me says run it as is
-
ConVerTT
22:30:19 10/17/17
Kent do the heads, while your at it. It's better now than
-
CmyZ
22:11:36 10/19/17
good point (n/m)
-
ConVerTT
23:58:17 10/21/17
Hmm
-
BlackholeZ
22:05:59 10/17/17
Thats what I would have thought too ...
-
ConVerTT
22:38:20 10/17/17
I wish I had a spare motor sitting around to play with... (n/m)
-
BlackholeZ
23:35:58 10/17/17
If that’s the motor you bought.
-
Aaronw
12:19:26 10/17/17
Looks pretty good! (n/m)
-
JMartz
13:53:15 10/17/17
Looks about right for a used engine
-
-Grimm-
14:14:54 10/17/17
So pretty close to my numbers on cylinder 3
-
ConVerTT
14:56:40 10/17/17
Nowhere near (reading the gauge backwards)
-
-Grimm-
15:31:32 10/18/17
#ValveRegrind????
-
MixManMash
19:10:52 10/18/17
ohhhh sorry! I thought you were using short hand...
-
ConVerTT
19:59:21 10/18/17
Cold is not the same, engine should be at operating temp
-
CmyZ
21:35:19 10/17/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.