Subject	It will be fine, maybe a valve has some crud and is stuck.
Posted by	CmyZ on October 17, 2017 at 9:32 PM
	This message has been viewed 291 times.
In Reply To	compression #'s posted by ConVerTT on October 17, 2017 at 01:07 PM
Message	Normally once you start it and warms up, it should be fine. Nothing to be worried about. But for peace of mind, I would take the heads off and have them done, install new gaskets. Cheap insurance against a future problem or another engine pull later..
Follow Ups	Leakdown test results...issues? - ConVerTT 11:42:57 10/17/17 My #3 is the lowest as well - BlackholeZ 12:07:28 10/17/17 What about 6? - ConVerTT 12:36:37 10/17/17 compression #'s - ConVerTT 13:07:52 10/17/17 Is that a running engine or one you just installed? (n/m) - DAYTONAZ 16:40:40 10/17/17 Just got it. Not installed yet. Those are cold numbers. - ConVerTT 17:01:15 10/17/17 In that case I wouldn't over think it - DAYTONAZ 13:27:27 10/18/17 It will be fine, maybe a valve has some crud and is stuck. - CmyZ 21:32:55 10/17/17 yeah so one side of me says run it as is - ConVerTT 22:30:19 10/17/17 Kent do the heads, while your at it. It's better now than - CmyZ 22:11:36 10/19/17 good point (n/m) - ConVerTT 23:58:17 10/21/17 Hmm - BlackholeZ 22:05:59 10/17/17 Thats what I would have thought too ... - ConVerTT 22:38:20 10/17/17 I wish I had a spare motor sitting around to play with... (n/m) - BlackholeZ 23:35:58 10/17/17 If that’s the motor you bought. - Aaronw 12:19:26 10/17/17 Looks pretty good! (n/m) - JMartz 13:53:15 10/17/17 Looks about right for a used engine - -Grimm- 14:14:54 10/17/17 So pretty close to my numbers on cylinder 3 - ConVerTT 14:56:40 10/17/17 Nowhere near (reading the gauge backwards) - -Grimm- 15:31:32 10/18/17 #ValveRegrind???? - MixManMash 19:10:52 10/18/17 ohhhh sorry! I thought you were using short hand... - ConVerTT 19:59:21 10/18/17 Cold is not the same, engine should be at operating temp - CmyZ 21:35:19 10/17/17
Post a Followup	You cannot reply to this message because you are not logged in.