Subject	If you had a lot of shims on stock springs
Posted by	BlackholeZ on September 26, 2017 at 11:45 PM
	This message has been viewed 369 times.
In Reply To	To FUCA or not to FUCA? Getting front alignment back in spec posted by nissubaru on September 26, 2017 at 09:41 PM
Message	then you likely have some underlying chassis issues. Hate to say it. 300D shims should be all that's needed. If you do enf up getting FUCAS, don't get cheapos. The cheap ones wander/come loose much easier than Powertrix/SPL. -Dan VTC Solenoid Caps href="http://goo.gl/GaK9E">and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	To FUCA or not to FUCA? Getting front alignment back in spec - nissubaru 21:41:54 09/26/17 If you had a lot of shims on stock springs - BlackholeZ 23:45:10 09/26/17 it's not just the cheap ones that come loose. the Z1 - slayer fan 11:28:57 09/27/17 Agreed, can't keep my jam/lock nuts tight even with locktite - WhiTTe Z 13:55:55 09/27/17 Thoughts... - Bernie (NoVA) 06:35:11 09/27/17
Post a Followup	You cannot reply to this message because you are not logged in.