Subject	Bel in Edmonton only uses king.
Posted by	dfenton2 on August 26, 2017 at 4:39 PM
	This message has been viewed 273 times.
In Reply To	What's everyone running for engine bearings these days? posted by Stanky (BC) on August 25, 2017 at 09:07 PM
Message	And they usually only deal with high hp drag engines. When I asked him what engine is his favorite. He said anything over 600 ci and over 1000hp. His shop had 3 supercharged 5.0 coyote Couple big block chevys also supercharged And a Chevy big block all torn apart with rods the size of my for arms. After being there and seeing that they only deal with very high hp racing engines not consumer based engines I knew that these guys knew what they were talking about and let them have free rain over the whole build.
Follow Ups	What's everyone running for engine bearings these days? - Stanky (BC) 21:07:53 08/25/17 Ask SZ. I think they swear by Clevite 77. - MixManMash 07:27:51 08/26/17 Also, I looked at ACLs after 30k kms of use and they - MixManMash 07:29:24 08/26/17 did you find the problem in your engine yet? (n/m) - dfenton2 22:00:08 08/27/17 Haven't even had time to pull it out yet. (n/m) - MixManMash 07:39:21 08/28/17 That's no good. I have barely found the time to even drive - dfenton2 08:42:38 08/28/17 I've been almost daily driving my Silver TT. (n/m) - MixManMash 17:33:59 08/28/17 Bel in Edmonton only uses king. - dfenton2 16:39:34 08/26/17 Clevite 77......no issues here. (n/m) - The Hawk 12:08:17 08/29/17
Post a Followup	You cannot reply to this message because you are not logged in.