Subject	Question
Posted by	EVLTWINZ on August 13, 2017 at 9:43 PM
	This message has been viewed 411 times.
In Reply To	I would just epoxy it. posted by Aaronw on August 13, 2017 at 08:04 PM
Message	If you have your car ready for primer. If there is small cut through's here and there. Go get your self a can of "sem self etch primer" and put a small coat of it on any bare metal spots. Then prime the car.
Follow Ups	Primer question - Bigmatthew86 09:10:30 08/12/17 Re: Primer question - ZXoltan 12:54:16 08/13/17 Re: Re: Primer question - Bigmatthew86 15:27:13 08/13/17 I would just epoxy it. - Aaronw 20:04:00 08/13/17 Question - EVLTWINZ 21:43:10 08/13/17 Re: Question - Bigmatthew86 07:46:31 08/14/17 Re: Re: Question - EVLTWINZ 12:16:41 08/14/17 Exactly what I did 7 years ago when I prepped my slicktop - black300zx 09:20:07 08/14/17 Re: Primer question - Bigmatthew86 16:02:50 08/14/17 As long as your going single stage, the 400 should be fine - ZXoltan 21:38:30 08/14/17 Also, if going metallic I would consider B/C rather than SS (n/m) - ZXoltan 08:18:20 08/15/17 Re: Also, if going metallic I would consider B/C rather than SS - Bigmatthew86 09:22:12 08/15/17 You don't say anything about "block sanding" the car - i-xclr8 20:24:35 08/18/17 Re: You don't say anything about "block sanding" the car - Bigmatthew86 11:30:11 08/19/17
Post a Followup	You cannot reply to this message because you are not logged in.