TwinTurbo.NET: Nissan 300ZX forum - just print out the wheel templates cut them out and glue to
Subject
just print out the wheel templates cut them out and glue to
Posted by
dfenton2
on June 08, 2017 at 6:12 PM
This message has been viewed
294
times.
In Reply To
Did u have to run spacers up front for caliper clearance? (n/m)
posted by Zu4ea
on June 08, 2017 at 12:00 AM
Message
The side of a cereal box. Then you'll know if your wheels will accept them or not.
Follow Ups
RPF1s and BBK
-
Zu4ea
02:14:19 06/07/17
I'm running rp03 with stoptech 14" bbk
-
dfenton2
08:41:28 06/07/17
Did u have to run spacers up front for caliper clearance? (n/m)
-
Zu4ea
00:00:09 06/08/17
no spacers. (n/m)
-
dfenton2
17:34:50 06/08/17
just print out the wheel templates cut them out and glue to -
dfenton2
18:12:59 06/08/17
RPF1's with 350Z Brembos (n/m)
-
SMAZ (OKC)
15:04:49 06/11/17
What size wheel and offset? And what size rotors? Thanks (n/m)
-
Zu4ea
00:56:24 06/12/17
8.5 +30, 10 +38. Whatever size the stock 350Z Brembos use (n/m)
-
SMAZ (OKC)
00:56:28 06/13/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.