Subject	It's not much
Posted by	BlackholeZ on May 21, 2017 at 12:18 AM
	This message has been viewed 247 times.
In Reply To	Looking for NA and TT bell-housing measurements. posted by Halo TTZ on May 20, 2017 at 11:30 AM
Message	I barely had to do any grinding to get my NA mounted over a TT flywheel. I did have to shim the starter. Without a tooling plate locating on the mounting holes, I'd doubt anyone could get any meaningful measurements. -Dan VTC Solenoid Caps href="http://goo.gl/GaK9E">and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Looking for NA and TT bell-housing measurements. - Halo TTZ 11:30:13 05/20/17 I'm new here so I'm not 100% - Vicious_boost 21:19:33 05/20/17 On some, only difference is the starter pad. - Doug71zt(CAN) 23:18:35 05/20/17 Do you have an assembled bottom end? - Doug71zt(CAN) 01:01:39 05/21/17 It's not much - BlackholeZ 00:18:26 05/21/17 Here's a helpful link I used when keeping my NA trans - PiotrC70 19:24:45 05/21/17 Measure how thick the starter flange is. TT is thicker - Bernie (NoVA) 16:18:48 05/22/17 gotcha! (n/m) - Halo TTZ 21:19:32 05/22/17 Gotcha boyeeeee - Guapo 22:51:37 05/22/17 boom!!!!!!! - Halo TTZ 16:24:13 05/23/17 ! (n/m) - Bernie (NoVA) 10:05:27 05/25/17
Post a Followup	You cannot reply to this message because you are not logged in.