Subject	Re: Really no reason not to reused the old hubs.
Posted by	njz on April 25, 2017 at 8:40 PM
	This message has been viewed 403 times.
In Reply To	Really no reason not to reused the old hubs. (n/m) posted by Bernie (NoVA) on April 25, 2017 at 07:15 PM
Message	I meant to say 1 hub L hub is 42mm half way and 43mm the rest of the way to the studs, any idea why? R hub 43mm the entire length" See below As government expands, liberty contracts.” – Ronald Reagan
Follow Ups	Nothing like new OEM parts - njz 14:33:41 04/25/17 OEM FTW (n/m) - ZaXxon 15:52:17 04/25/17 Really no reason not to reused the old hubs. (n/m) - Bernie (NoVA) 19:15:55 04/25/17 Notch the old bearing collar with a Dremel and it will crack - Bernie (NoVA) 19:16:42 04/25/17 I tried that - BlackholeZ 19:38:14 04/25/17 Dunno - never really had any problems getting them apart - Bernie (NoVA) 10:30:42 04/26/17 I'm not sure why it was such a pain - BlackholeZ 11:20:16 04/26/17 Re: Really no reason not to reused the old hubs. - njz 20:40:45 04/25/17 Production change over the years - likely replaced prior. - Bernie (NoVA) 22:25:21 04/25/17 Has anyone found a source for the bearings alone for a TT? - zxtuner161 23:10:51 04/26/17 43280-AA300 is the bearing alone. - Bernie (NoVA) 01:48:56 04/27/17 Check the classifieds in the next 12 hours - ZXoltan 21:06:35 04/28/17 Too late for that :-) (n/m) - Bernie (NoVA) 19:09:54 05/09/17
Post a Followup	You cannot reply to this message because you are not logged in.