TwinTurbo.NET: Nissan 300ZX forum - I was able to pin point it to the tension rod ends and the
People Seeking Info
 
   


     
Subject I was able to pin point it to the tension rod ends and the
     
Posted by ZaXxon on April 25, 2017 at 3:51 PM
  This message has been viewed 416 times.
     
In Reply To Re: are your SPL pieces making noise? i.e. creaking? posted by L£AÐZX on April 24, 2017 at 07:54 PM
     
Message upper control rod ends. If you push down on that specific corner, you can clearly hear that it's the rod ends.

And yes, I realized after I tried lubricating them that I shouldn't have. It can attract contaminants into the spherical bushing and damage it.

Now, I just try to keep them aligned properly when I have access to them.

DSCN1525

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.