TwinTurbo.NET: Nissan 300ZX forum - I wouldn't be surprised that a manifold would be needed
People Seeking Info
 
   


     
Subject I wouldn't be surprised that a manifold would be needed
     
Posted by BlackholeZ on April 17, 2017 at 3:48 PM
  This message has been viewed 377 times.
     
In Reply To The turbine housing is much longer than equivalent Garrett posted by MixManMash on April 17, 2017 at 02:17 PM
     
Message At the same time I just built the header for my FSAE car and I'm kind of addicted now. I'll see what things look like whenever I get there. In 2 years when I'd realistically be looking at it it's possible there will be a smaller GTX. I've also had my eyes on the MGT turbos like what are going on the VR30DDTT. I'd have to come up with a solution for the turbine housing but depending that could be easier than doing a custom manifold.

-Dan
VTC Solenoid Caps and install instructions.


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne

" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.