Subject	Oh yeah I had forgotten about that
Posted by	BlackholeZ on February 11, 2017 at 12:20 PM
	This message has been viewed 206 times.
In Reply To	FWIW - the motor was designed, prototyped and road tested posted by Bernie (NoVA) on February 10, 2017 at 07:18 PM
Message	I was actually talking to someone the other day about the front suspension and how it's designed to make as much engine bay room as possible without going to a MacPherson strut. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Lower intake modification to accept R35 upper - Obsolete84 18:45:07 02/09/17 better off getting uber headwork done for the $$ (n/m) - LJZTT 20:29:17 02/09/17 Assuming headwork has been done... (n/m) - Obsolete84 20:48:10 02/09/17 The GR plenum is tuned for the motor it is designed for. (n/m) - Bernie (NoVA) 21:49:02 02/09/17 The big difference is the angle that the runner meets - BlackholeZ 00:27:26 02/10/17 This. (n/m) - MixManMash 03:18:41 02/10/17 Very informative answer and I appreciate the response - Obsolete84 11:00:37 02/10/17 FWIW - the motor was designed, prototyped and road tested - Bernie (NoVA) 19:18:55 02/10/17 Oh yeah I had forgotten about that - BlackholeZ 12:20:05 02/11/17 Profile says 100% stock..... - The Hawk 10:22:24 02/10/17 oh yea the profile that I haven't changed or updated in - Obsolete84 21:13:18 02/10/17
Post a Followup	You cannot reply to this message because you are not logged in.