Subject	Not a bad idea for the tube seals while you are in there!
Posted by	jzack on February 10, 2017 at 9:35 AM
	This message has been viewed 278 times.
In Reply To	Re: Forgot to mention...also get new half moon plugs for the posted by Bigmatthew86 on February 10, 2017 at 08:46 AM
Message	BTW - Permatex Ultra Copper is a good RTV for the exhaust VCs. You'll also need a little dab for the intake VC "corners". That is, any place where the VC surface changes direction to go up/down (over the CAM ends or VTC solenoids). You'll also want to remove and reseal the VTC solenoids. Clean up prep is the worst part of this job....takes a long time remove the old hard sealant.
Follow Ups	First plenum pull - Bigmatthew86 07:32:25 02/10/17 Some other things: Delete the under plenum coolant hoses - jzack 08:28:42 02/10/17 Forgot to mention...also get new half moon plugs for the - jzack 08:38:40 02/10/17 Re: Forgot to mention...also get new half moon plugs for the - Bigmatthew86 08:46:00 02/10/17 Should have got the BDE half moons.... (n/m) - MixManMash 08:53:10 02/10/17 Not a bad idea for the tube seals while you are in there! - jzack 09:35:39 02/10/17 Re: First plenum pull - Smokiedabear 09:35:37 02/10/17 Re: Re: First plenum pull - Bigmatthew86 10:14:53 02/10/17 Re: Re: Re: First plenum pull - Smokiedabear 11:05:48 02/10/17 And if you can recheck a day or so later and lightly tighten - jzack 09:08:57 02/11/17 PCV delete. (n/m) - ForceFedTT (SoCal) 17:31:39 02/10/17
Post a Followup	You cannot reply to this message because you are not logged in.