Subject	Assuming headwork has been done... (n/m)
Posted by	Obsolete84 on February 09, 2017 at 8:48 PM
	This message has been viewed 253 times.
In Reply To	better off getting uber headwork done for the $$ (n/m) posted by LJZTT on February 09, 2017 at 08:29 PM
Message
Follow Ups	Lower intake modification to accept R35 upper - Obsolete84 18:45:07 02/09/17 better off getting uber headwork done for the $$ (n/m) - LJZTT 20:29:17 02/09/17 Assuming headwork has been done... (n/m) - Obsolete84 20:48:10 02/09/17 The GR plenum is tuned for the motor it is designed for. (n/m) - Bernie (NoVA) 21:49:02 02/09/17 The big difference is the angle that the runner meets - BlackholeZ 00:27:26 02/10/17 This. (n/m) - MixManMash 03:18:41 02/10/17 Very informative answer and I appreciate the response - Obsolete84 11:00:37 02/10/17 FWIW - the motor was designed, prototyped and road tested - Bernie (NoVA) 19:18:55 02/10/17 Oh yeah I had forgotten about that - BlackholeZ 12:20:05 02/11/17 Profile says 100% stock..... - The Hawk 10:22:24 02/10/17 oh yea the profile that I haven't changed or updated in - Obsolete84 21:13:18 02/10/17
Post a Followup	You cannot reply to this message because you are not logged in.