Subject	Waking the beast
Posted by	PunkZTT(Phoenix) on December 19, 2016 at 9:27 PM
	This message has been viewed 460 times.
Message	Waking the Z up from a long slumber. It has been a few years since she has breathed some air. A couple notes - Just wanted to report that my SS fuel lines would not hold up to seafoam being stored in them (prescribed amount used). I have had 3 lines fail and leak all over the engine bay. Lots of gasoline! I am guessing it may be the seafoam but could possibly be low quality fuel line. Second note - One Nismo 555cc injector clogged from varnish I assume? Maybe fuel line bits? Over all - Looking forward to a winter in AZ with the Z. Cheers
Follow Ups	Waking the beast - PunkZTT(Phoenix) 21:27:06 12/19/16 SS fuel lines are likely not for fuel injection applications - Bernie (NoVA) 22:36:23 12/19/16 You mean greater than 14 ohms. (n/m) - MixManMash 23:51:30 12/19/16 or less than 10. But yeah, I've only seen number read higher (n/m) - PiotrC70 09:05:58 12/20/16 psst..he's correcting Bernie's 14*v* typo ;P (n/m) - dogpile 10:29:47 12/20/16 I know. :) Figure the guy should know the other end of the - PiotrC70 14:57:07 12/20/16 Lies (n/m) - dogpile 09:03:42 12/21/16 10-14 Ohms is the acceptable range. (n/m) - Bernie (NoVA) 10:48:12 12/21/16
Post a Followup	You cannot reply to this message because you are not logged in.