Subject	Re: I would reduce the stiffness on the rear and try again.
Posted by	cosmonautpetrov on November 10, 2016 at 5:10 PM
	This message has been viewed 448 times.
In Reply To	I would reduce the stiffness on the rear and try again. (n/m) posted by MixManMash on November 09, 2016 at 01:54 PM
Message	Thanks, reduced rear stiffness and still felt a bit too oversteer biased, so I stiffened up the front bar and now it feels perfect. Is this what the front stillen link is supposed to look like? The only way I could get it through the middle hole was to unscrew the joint part a bit, but now there's a space between the nut holding the bushings and the joint. Won't the nut unscrew itself over time and make the bushings loose or will it be held in place by the bushing pushing on it? [ http://imgur.com/a/pQh6G ]
Follow Ups	stillen adjustable swaybar setup for best cornering? - cosmonautpetrov 11:52:37 11/09/16 I would reduce the stiffness on the rear and try again. (n/m) - MixManMash 13:54:58 11/09/16 Re: I would reduce the stiffness on the rear and try again. - cosmonautpetrov 17:10:37 11/10/16 Re: Re: I would reduce the stiffness on the rear and try again. - cosmonautpetrov 17:32:56 11/10/16 Re: Re: Re: I would reduce the stiffness on the rear and try again. - cosmonautpetrov 18:02:43 11/10/16
Post a Followup	You cannot reply to this message because you are not logged in.