TwinTurbo.NET: Nissan 300ZX forum - I would recommend you get the 2860s.
People Seeking Info
 
   


     
Subject I would recommend you get the 2860s.
     
Posted by MixManMash on September 27, 2016 at 7:47 PM
  This message has been viewed 437 times.
     
In Reply To Build outline posted by Nathan_O on September 27, 2016 at 07:17 PM
     
Message I haven't seen the manifolds required to fit EFRs for sale, but maybe I am wrong. But the manifold that I did see would have me worried about cracking versus a cast manifold (MSP).

I would say you should get the 2860s from Specialty Z. Also, I would so full intake/exhaust breather mods (MSP manifolds, Ashspec IC/IC Piping/Inlet piping/Selin translator/ dual pop.)

If you want faster spool-up, I would recommend doing JWT 500 cams with valve springs, BDE adjustable cam gears. Optionally, ported cylinder heads, 5 angle valve job, maybe 0.5mm oversized valves.

The big key is going to be getting it custom tuned. Specialty Z are very good at tuning and can also recommend parts/upgrades to meet your goals.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.