Subject	Post some pictures up of the coated flanges. (n/m)
Posted by	MixManMash on July 11, 2016 at 6:57 AM
	This message has been viewed 296 times.
In Reply To	I guess my post wasn't clear enough. I already have posted by Inzane on July 10, 2016 at 10:41 PM
Message
Follow Ups	Question for those WITH coated exh manifolds and/or turbine - Inzane 11:09:53 07/09/16 Leave it alone. It's a relatively thin coating and the meta - MixManMash 11:53:35 07/09/16 *metal. (n/m) - MixManMash 12:06:07 07/09/16 I spoke to PolyDyn today and that is basically what they - Inzane 19:05:56 07/11/16 I sand down all my metal mating surfaces before bolting them - vorpalZ 12:07:05 07/09/16 Hmmm. My guy does NOT coat the mating surfaces, so I am - ConVerTT 19:00:37 07/09/16 Re: Question for those WITH coated exh manifolds and/or turbine - Bigwill837 19:03:26 07/09/16 I guess my post wasn't clear enough. I already have - Inzane 22:41:05 07/10/16 Post some pictures up of the coated flanges. (n/m) - MixManMash 06:57:33 07/11/16 Strip the mating surface for your own piece of mind... - ConVerTT 21:25:25 07/11/16 although.... - ConVerTT 22:36:06 07/11/16
Post a Followup	You cannot reply to this message because you are not logged in.