TwinTurbo.NET: Nissan 300ZX forum - the moog tie rods and ball joints i put on my car
Subject
the moog tie rods and ball joints i put on my car
Posted by
slayer fan
on May 24, 2016 at 11:57 AM
This message has been viewed
547
times.
In Reply To
So yours are made in Korea, Bernie?
posted by ZXoltan
on May 24, 2016 at 08:02 AM
Message
were made in japan. however, that was two years ago. last week i put a moog wheel bearing on my wife's g35 and it is made in korea. i would think korea would be better than china.
Follow Ups
Are aftermarket tie rods (inner & outer) from CZP any good?
-
ZEngineer
01:22:58 05/24/16
I stock older Moog & OEM Nissan units.
-
Bernie (NoVA)
06:25:20 05/24/16
So yours are made in Korea, Bernie?
-
ZXoltan
08:02:43 05/24/16
the moog tie rods and ball joints i put on my car -
slayer fan
11:57:45 05/24/16
My current stock has Moog from Korea and Nissan from Japan. (n/m)
-
Bernie (NoVA)
17:38:08 05/24/16
Post a
Followup
You cannot reply to this message because you are not
logged in
.