Subject	Stands + nixit blocks. (n/m)
Posted by	BoneZ (MD) on May 21, 2016 at 1:38 PM
	This message has been viewed 290 times.
In Reply To	if car is on stands, couldn't you use the jack to raise the posted by LJZTT on May 18, 2016 at 08:16 PM
Message
Follow Ups	How to avoid destroying Tension Rod ends? - ZEngineer 13:21:34 05/18/16 You are on the right track - ttsmokin 14:20:51 05/18/16 Thank you. This is helpful. But if I'm installing them - ZEngineer 17:04:38 05/18/16 I install them twisted close to the limit. That seems - not4resaleZ 17:20:50 05/18/16 if car is on stands, couldn't you use the jack to raise the - LJZTT 20:16:21 05/18/16 You could set the car on blocks under the wheels, - not4resaleZ 09:30:09 05/19/16 seems a lot more unsafe to actually have the weight of the - LJZTT 13:11:40 05/19/16 If you lift the wheels into a similar position, the weight - not4resaleZ 16:28:36 05/19/16 not if you don't raise the car off the stands - LJZTT 18:11:58 05/19/16 Stands + nixit blocks. (n/m) - BoneZ (MD) 13:38:07 05/21/16 Do you require a custom caster setting up front? - Polish 14:21:02 05/18/16 I haven't had issues with these tension rods - ZEngineer 17:02:55 05/18/16 Upgrade to SPL and send your old units in as cores (n/m) - Bernie (NoVA) 16:34:25 05/18/16 In which way is the SPL an upgrade? (Legitimate question) (n/m) - ZEngineer 17:01:50 05/18/16 Better brake air deflectors. (n/m) - not4resaleZ 17:22:47 05/18/16 Lol! (n/m) - ForceFedTT (SoCal) 20:02:22 05/18/16 *. * - Bernie (NoVA) 21:16:44 05/18/16 Now if they only would come out with new FUCAs... With the - MixManMash 21:47:53 05/18/16
Post a Followup	You cannot reply to this message because you are not logged in.