Subject	Upgrade to SPL and send your old units in as cores (n/m)
Posted by	Bernie (NoVA) on May 18, 2016 at 4:34 PM
	This message has been viewed 401 times.
In Reply To	How to avoid destroying Tension Rod ends? posted by ZEngineer on May 18, 2016 at 01:21 PM
Message
Follow Ups	How to avoid destroying Tension Rod ends? - ZEngineer 13:21:34 05/18/16 You are on the right track - ttsmokin 14:20:51 05/18/16 Thank you. This is helpful. But if I'm installing them - ZEngineer 17:04:38 05/18/16 I install them twisted close to the limit. That seems - not4resaleZ 17:20:50 05/18/16 if car is on stands, couldn't you use the jack to raise the - LJZTT 20:16:21 05/18/16 You could set the car on blocks under the wheels, - not4resaleZ 09:30:09 05/19/16 seems a lot more unsafe to actually have the weight of the - LJZTT 13:11:40 05/19/16 If you lift the wheels into a similar position, the weight - not4resaleZ 16:28:36 05/19/16 not if you don't raise the car off the stands - LJZTT 18:11:58 05/19/16 Stands + nixit blocks. (n/m) - BoneZ (MD) 13:38:07 05/21/16 Do you require a custom caster setting up front? - Polish 14:21:02 05/18/16 I haven't had issues with these tension rods - ZEngineer 17:02:55 05/18/16 Upgrade to SPL and send your old units in as cores (n/m) - Bernie (NoVA) 16:34:25 05/18/16 In which way is the SPL an upgrade? (Legitimate question) (n/m) - ZEngineer 17:01:50 05/18/16 Better brake air deflectors. (n/m) - not4resaleZ 17:22:47 05/18/16 Lol! (n/m) - ForceFedTT (SoCal) 20:02:22 05/18/16 *. * - Bernie (NoVA) 21:16:44 05/18/16 Now if they only would come out with new FUCAs... With the - MixManMash 21:47:53 05/18/16
Post a Followup	You cannot reply to this message because you are not logged in.