Subject	We used a cubic yard for each lift pit. Cost about $400 aft
Posted by	Gordo 93TT Daytona on April 16, 2016 at 3:26 PM
	This message has been viewed 622 times.
In Reply To	Address please? posted by zgene4 on April 16, 2016 at 02:43 PM
Message	after surcharges, etc for less than min load of eight (8) cubic yards. _________________________________________________
Follow Ups	Finally got a lift - - Gordo 93TT Daytona 14:04:28 04/16/16 Address please? - zgene4 14:43:49 04/16/16 We used a cubic yard for each lift pit. Cost about $400 aft - Gordo 93TT Daytona 15:26:36 04/16/16 Install used gantry. Each unit weighs 800 lbs. - Gordo 93TT Daytona 15:34:14 04/16/16 A gantry is such an underrated tool - BlackholeZ 11:47:59 04/17/16 We use one for pulling and installing engines in Z32s. - MixManMash 13:04:09 04/17/16 NICE! How tall is your ceiling? Thanks (n/m) - SammybTT(TN) 17:37:26 04/17/16 Ceilings are 12 foot. (n/m) - Gordo 93TT Daytona 18:23:06 04/17/16 Nice - be careful working around the open area (n/m) - Bernie (NoVA) 15:53:23 04/16/16 Biggest issue is small parts falling into pit. - Gordo 93TT Daytona 18:22:06 04/17/16 Awesome setup...congrats! (n/m) - Madhatter10-6 19:44:04 04/16/16 If you don't mind... - -Grimm- 23:44:27 04/16/16 Holden Engineering, Orlando FL - Phil Holden - Gordo 93TT Daytona 12:40:36 04/17/16 Congrats. Looks very nice. That will make - Boosted1 17:34:10 04/17/16 Looks great. Definitely jealous but... - Zbullet 19:46:02 04/17/16 I usually used spacers to the normal jacking points. - BlackholeZ 20:15:34 04/17/16 I'm using 6" long, 1.5" high hard rubber spacers (4" wide) - Gordo 93TT Daytona 10:57:48 04/18/16 That's the ultimate flying Z picture! - OverZealous (CT) 19:49:49 04/19/16 Looked at your profile, how well does Ash chip with boost... - David G 00:12:37 04/20/16 I am probably not the best qualified to answer that Q. - Gordo 93TT Daytona 16:34:58 04/21/16
Post a Followup	You cannot reply to this message because you are not logged in.