Subject	No, I've had a hard time removing it and staying level.
Posted by	Jinjiro on April 06, 2016 at 10:51 AM
	This message has been viewed 314 times.
In Reply To	Are you keeping it level when you remove it? posted by Woody75 (Denver) on April 06, 2016 at 10:34 AM
Message	Maybe there's a trick to it that I'm missing? I usually have to tip it back slightly, and then level it off once it's back far enough. But I always wind up losing a bit of oil in the process.
Follow Ups	Tail Shaft Plug? - Jinjiro 09:57:37 04/06/16 Are you keeping it level when you remove it? - Woody75 (Denver) 10:34:39 04/06/16 No, I've had a hard time removing it and staying level. - Jinjiro 10:51:27 04/06/16 Re: Tail Shaft Plug? - BarryGZX 12:44:52 04/06/16 Same here. (n/m) - white22sky 14:40:53 04/06/16 This, just get one from a junkyard. (n/m) - BlackholeZ 15:13:38 04/06/16 I use this Powerbuilt 940376 - ThisIsSparTTa 14:35:27 04/06/16 2nd. I think HF also carries them (n/m) - BoneZ (MD) 21:08:07 04/06/16 I made one using delrin - ZXRider 16:45:39 04/06/16 I just use a cut off stock drive shaft flange. (n/m) - Bernie (NoVA) 17:33:47 04/06/16 ^^That and zip ties so it doesn't fall on your head. (n/m) - ILoveBoost 12:35:05 04/07/16
Post a Followup	You cannot reply to this message because you are not logged in.