Subject	Re: Does that washer and snap ring replace the oem pressed on
Posted by	ttz'in (norcal) on April 03, 2016 at 10:26 PM
	This message has been viewed 269 times.
In Reply To	Does that washer and snap ring replace the oem pressed on posted by itsa300zx on April 03, 2016 at 10:16 PM
Message	Snap ring fits in the groove on shifter shaft.
Follow Ups	Shifter boot replacement question - aquariuscsm 12:39:07 04/03/16 Re: Shifter boot replacement question - ttz'in (norcal) 13:23:23 04/03/16 don't forget to transfer the white plastic retainer ring - itsa300zx 13:53:35 04/03/16 Mine must be long gone - aquariuscsm 15:50:17 04/03/16 Classified, best bet would be someone parting out manual car (n/m) - itsa300zx 16:19:29 04/03/16 I found these two pieces - aquariuscsm 16:31:16 04/03/16 Link inside...step 3 photo on top of rubber dust boot - itsa300zx 16:42:58 04/03/16 That would be the snap ring.. Good find. (n/m) - ttz'in (norcal) 21:40:41 04/03/16 Does that washer and snap ring replace the oem pressed on - itsa300zx 22:16:17 04/03/16 Re: Does that washer and snap ring replace the oem pressed on - ttz'in (norcal) 22:26:56 04/03/16 No snap ring on OEM shifter. You're thinking of the Stillen - Bernie (NoVA) 22:43:59 04/03/16 Thanks everyone for the help! - aquariuscsm 06:59:40 04/04/16 Also a good time to replace the shifter bushing... - CameronSF 21:32:16 04/03/16 Stock bushings vs SPL type for shifting feel - aquariuscsm 22:42:42 04/06/16
Post a Followup	You cannot reply to this message because you are not logged in.