Subject	Does your motor not tip back for some reason?
Posted by	BlackholeZ on March 15, 2016 at 1:37 PM
	This message has been viewed 301 times.
In Reply To	I've installed a few different clutches and flywheels on my posted by dfenton2 on March 14, 2016 at 11:57 PM
Message	With the rear trans mount off you can usually tip the motor back and have no trouble getting to the top bolts. This may have been why you were having so much trouble. I try to avoid dropping the crossmember whenever possible because cars never seem to align quite right afterwards. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	RPS Triple Carbon Clutch Install - dfenton2 00:35:24 03/14/16 They're smaller than normal clutches - BlackholeZ 02:37:10 03/14/16 They're smaller in diameter but taller front to rear in car. - Boosted1 05:04:00 03/14/16 Re: They're smaller in diameter but taller front to rear in car. - dfenton2 09:20:38 03/14/16 So they have to use a different throwout bearing - BlackholeZ 17:25:42 03/14/16 yes - dfenton2 18:50:20 03/14/16 If the throwout bearing is the same, - BlackholeZ 22:38:23 03/14/16 I've installed a few different clutches and flywheels on my - dfenton2 23:57:19 03/14/16 Does your motor not tip back for some reason? - BlackholeZ 13:37:10 03/15/16 this is what I always do^^^ tilt the engine back. (n/m) - itsa300zx 14:00:30 03/15/16 Yep. I tilt it back. Sometimes I have had to disconnect - MixManMash 17:06:53 03/15/16
Post a Followup	You cannot reply to this message because you are not logged in.