Subject	They're smaller than normal clutches
Posted by	BlackholeZ on March 14, 2016 at 2:37 AM
	This message has been viewed 342 times.
In Reply To	RPS Triple Carbon Clutch Install posted by dfenton2 on March 14, 2016 at 12:35 AM
Message	how in the hell was it harder? Sounds like you didn't have the plates lined up or something. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	RPS Triple Carbon Clutch Install - dfenton2 00:35:24 03/14/16 They're smaller than normal clutches - BlackholeZ 02:37:10 03/14/16 They're smaller in diameter but taller front to rear in car. - Boosted1 05:04:00 03/14/16 Re: They're smaller in diameter but taller front to rear in car. - dfenton2 09:20:38 03/14/16 So they have to use a different throwout bearing - BlackholeZ 17:25:42 03/14/16 yes - dfenton2 18:50:20 03/14/16 If the throwout bearing is the same, - BlackholeZ 22:38:23 03/14/16 I've installed a few different clutches and flywheels on my - dfenton2 23:57:19 03/14/16 Does your motor not tip back for some reason? - BlackholeZ 13:37:10 03/15/16 this is what I always do^^^ tilt the engine back. (n/m) - itsa300zx 14:00:30 03/15/16 Yep. I tilt it back. Sometimes I have had to disconnect - MixManMash 17:06:53 03/15/16
Post a Followup	You cannot reply to this message because you are not logged in.