TwinTurbo.NET: Nissan 300ZX forum - tomato tomato
People Seeking Info
 
   


     
Subject tomato tomato
     
Posted by BlackholeZ on March 08, 2016 at 4:57 PM
  This message has been viewed 321 times.
     
In Reply To Most likely an injection molded part posted by ZXRider on March 08, 2016 at 12:14 PM
     
Message Mold/cast.That's what I was meaning. It was definitely injection molded. My problem was not with the bulk shaping, but the surface finish that they applied after the molding process.

-Dan
VTC Solenoid Caps and install instructions.


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne

" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.