TwinTurbo.NET: Nissan 300ZX forum - Most likely an injection molded part
Subject
Most likely an injection molded part
Posted by
ZXRider
on March 08, 2016 at 12:14 PM
This message has been viewed
318
times.
In Reply To
I was rather disappointed with the ZThirtyTwo bezel
posted by BlackholeZ
on March 07, 2016 at 08:42 PM
Message
it would be very unlikely for it to be made through resin casting since ABS is not a thermosetting polymer.
Follow Ups
Double Din Bezel options
-
MeatMan
19:03:24 03/07/16
I am a doofus, my links didnt work. Cut + paste to see (n/m)
-
MeatMan
19:04:34 03/07/16
Re: Double Din Bezel options
-
Davez
19:48:52 03/07/16
That was I thought too. Wrong. Its concept is a lesser copy. (n/m)
-
Boosted1
20:29:30 03/07/16
the other one is interior innovations, no?
-
Antihero
00:00:53 03/08/16
I can speak to that Q firsthand.
-
Boosted1
20:28:19 03/07/16
I was rather disappointed with the ZThirtyTwo bezel
-
BlackholeZ
20:42:14 03/07/16
Most likely an injection molded part -
ZXRider
12:14:14 03/08/16
tomato tomato
-
BlackholeZ
16:57:30 03/08/16
The texture is added into the mold cavity
-
ZXRider
21:27:12 03/08/16
I got you meng :-)
-
BlackholeZ
13:47:30 03/09/16
I've never seen the ZThirtyTwo bezel in person
-
ZXRider
15:16:06 03/09/16
both bezels don't match the interior plastics
-
vorpalZ
09:16:18 03/08/16
I had bought both.
-
Woody75 (Denver)
11:37:46 03/08/16
The plastic is better from Interior Innovations, however...
-
Jonathan (Specialty Z)
12:18:09 03/08/16
ZThirtyTwo double din is garbage.
-
Mike TDK (NoVA)
07:52:32 03/09/16
Post a
Followup
You cannot reply to this message because you are not
logged in
.